Finished up the driver board today.  Replaced one header connector along with resolding the rest of the pins.  There is bunch of header pins to do.  I just remove the old solder, and then applied new.

Added the 0 ohm resistors along with the IRF9Z34N Mosfet transistor to the lamp column drive section of the board.  Also replaced the the transistors (2N4401 and TIP102) in the special solenoid driver section.

Next step is to put this on my bench and see if it is working.

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *